Meanwell NES-350-12 Cover for MK2

prusaprinters

<p>This is a remix of mmoore0s great power supply cover. I made the original and broke 2 of them while mounting so I reinforced 3 of the sides and also added the MK2 mounting lug so I could mount it on my clone. It would allow you to use the larger meanwell on any MK2 style frame though. I also, rather than drilling the frame, added the included block and used it with double sided tape to secure the top of the power supply to the frame. I think you could leave that off and the screws at the bottom would be enough to hold it in place if your printer doesnt move much but I just wanted to make sure the top was secured to the frame. I printed the one in the pictures with E3D edge crystal. It looks good and has done the job well so far.</p> Category: 3D Printer Parts