MeiCelet 78mm x 98mm Airsoft Ball Bearing

thingiverse

I made this bracelet for my step mom and named it after her. I have been beveling the edges slightly where the raceways meet at the glue joint to good effect.hand sanding the inner ring where it will contact the wearers arm and painting it with acetone will smooth it for hours of comfortable wear. Carefully glue with acetone the inside race together. very light and check for penetration. any globs will be a bump for the airsoft balls to get past. trim along the raceway and assemble. put the inner race inside the one of the outers and load it with 6mm Airsoft balls.snap the other half down - evey one I have made held together by itself at this point. if it spins freely enough glue it carefully