mer_at Mouse Bungee w/ extended arm clip and back bearing cover.

thingiverse

"MB Riser" & "MBCover" are the included updated pieces. The original print still had wire drag and I also didn't like the exposed bearing in the back. Please note the extender does not need to be glued in the whole unless you printed it too big. Regardless, it is intended to fit snugly and not move so its okay if it needs to be super glued into place. I'd recommend the orientation shown in the picture. If you happened to print the included original wire holder and didnt glue it in place, you can glue it onto the base in the back to act as a wire guide. Printed the cap and extended arm at .15. Used a brim. Bones were printed at .15, base .20. The bearing cap needs no resizing and should fit a 608RS bearing easily. Ender 3 V2 using PLA+ by CC3D. This extended arm helped with lifting the cord which the original design didn't really fix. Also, I highly recommend Poster Putty for the feet. I used 5 small rolled balls of it and smushed them down. The weight of the base is enough to keep it in place and reusing/repositioning is perfect. Please note: i left the monitor clamps out and chose the older design for the 2nd bone. If you'd like either of those, please download from the original uploader post.