Mera Mera no Mi (Flare Flare Devil Fruit)

thingiverse

DaRedNoseRat's Mera Mera fruit split into the fruit and the stem like the Gomu Gomu fruit model for easier printing. As a head's up, the stem is the gomu gomu no mi stem. The hole for the stem is the exact size as the stem so you'll have to either scale the stem down or use a setting like cura's hole horizontal expansion to make the hole in the fruit a little bigger to get them to fit together. There's a small square at the bottom of the model which should be too small to be an issue but if it is then at least in cura it's easy to move the model below the build plate to cut that part off. I printed the fruit at 100% and the stem at 90% (rotated 90 degrees so it's on it's side with brim and support) and they fit together well. I did my best to straighten the model but it's slightly tilited so at larger sizes you may need to lower the model slightly (0.1mm at 200%) to make sure the bottom is flat.