Mew Mew Modular Desk Tidy System V2

thingiverse

Mew Mew is a modular desk tidy system created by brendandawes so you can keep you pencils, pens, paper-clips and other office supply goodies neat and tidy on your desk. The system allows you to combine the hexagon based Mew Mew in different ways; each Honey Pot slides together simply and easily. Using brendandawes' skecthup I widened the openings a bit and flattened the bottom to waste slightly less material, so it fits just fine with no additional filing. I tested it on my Ultimaker and it works perfectly, so there shouldn't be any problems. Any comments are welcome, whether you think this is better than the original brendandawes version and why, or not :) Update: Added a 10mm and a 70mm version, to give some variety. Instructions I used Ultimaker with gcode made using Cura with Layer height 0.2mm, Shell thickness 1.8mm, Bottom/Top Thickness 1.2mm, 100% Fill Density and 100 mm/s Print speed (I leaned a bit on the safe side, you should be fine with 150mm/s). I sued no Support type and no Platform adhesion type, and my filament had 1.75mm diameter and 100% flow. BTW, with this print, if you use shell thickness less than 1.6mm, you get a gap in the middle, which you want to avoid - which is why I used 1.8mm shell thickness.