MG Flux & Solder Paste Holder

thingiverse

Looked around for a holder for my MG Chemicals Flux & Solder Paste and couldn't really find any I liked. So I made these mounts for it. It's fairly close tolerances so it doesn't wobble around. So if it is too tight or loose for it when you make it, easiest way is just scale it up or down a couple percent as needed. I designed it to use double-sided tape to attach to my Hakko 611-2 Dual Solder Reel Stand and it works perfectly. I have 2 on each side of the stand but you could easily fit another on each side if needed. If you size it up about 5-7% it will also work as a holder for the cheap solder pumps (as seen in picture). I also added a model with screw holes if you would prefer to screw it into something rather than tape it. The holes are tapered 4mm.