Micro HKPilot Mega Master Set GPS Case u-Blox NEO-6 and HMC5883

thingiverse

I purchased the HKPilot Master Set on HK.com Since there is no housing to buy, I designed one. There are two holes for the LEDs on the GPS module. I designed it to put on a piece of transparent 1.75mm filament. It works well. The GPS Module fits very good in this case. You just need to put a piece of foam if you close it, to make sure the module is not shaking. The Screws you need are M3x8mm with countersunk sorry for bad english cheers Print Settings Printer: Print Rite 3D Colido 3D Printer Rafts: Doesn't Matter Supports: No Resolution: 0,2 Infill: 10%