Micro quad V1 remix tor Hubsan X4

cults3d

I had a Hubsan X4 which I stripped and mounted into the V2 dream catcher frame, As the wires were short and soldered on to the FC its snapped a wire off when I had a heavy landing. I decided to remix the V1 frame to take all the Hubsan parts. The frame has mounts for 7mm motors and a recess in the centre for FC and the battery. I made a slot down the arms to take the cables and LED's. The holes in the arms near the FC have been opened up to 7.5mm so the motors can be pushed through the arm and then back in to the mounts, this allows the parts to be fitted and removed without unsoldering the wires. The battery is held in place with loom bands hooked on the lugs at the sides. The LED's are popped into the slots of each arm and held with a small dot of hot glue. I printed it in natural PLA so the LED's light the frame up nice. The frame weighs 14g when printed and it is 40g total all up which is the same as the V2 build I made. I will try and upload some vids soon. Thanks to http://www.thingiverse.com/MicroMotorWarehouse/about Hope you enjoy it.