Micro Swiss Hot End Cooler With BL Touch

thingiverse

MicroSwiss Direct Drive Cooler (duel fan part cooling) With BL Touch For Ender 3 V2. This is a slightly modified version of my other cooler that now includes the mount for the BL Touch. This was included after some feedback asking for it to be included. (thank you to those that did) It will print with some support required to get the best out of it. but should be straight forward enough. make sure the support is only from the bed and not internally as you will not be able to remove it once the print it done. the BL Touch is 40mm left and 5mm forwards from the nozzle centre. as with the previous design the part cooling gives a blanket covering around the area of the nozzle and does not blow directly at the nozzle. this gives 2 advantages. the extruded filament cools is all directions and has a larger blanket of cooling air than a focused stream of air. the nozzle is not as exffected by the part cooling air, so the nozzle is able to keep its temp better. I have been using this set up for nearly a year now and personaly i find it to perform better than others that use a focused air stream. please leave feed back if you have any problems with this print. i do not own a BL Touch and so have not tested this print. all dimentions have been tacken from the BL Touch web page.