microSD Card and Reader Holder - Larger Reader

prusaprinters

<p>The hole is about 22 mm in diameter and 20 mm deep, which gives some room for the Sandisk MobileMate SDDR-B531-GN6NN.&nbsp;</p><p>I imported the original STL and sliced up the cylinder, then duplicated slices until I got enough height. Because I wanted to maintain the knurling on the outside, I could only lengthen it in ~4 mm increments. It's actually a bit too deep for the card reader--it will fall out of the slot if the case is turned upside down.</p><p>Settings don't matter too much but you may have to reduce printing speed for the inner threads to come out correctly.&nbsp;</p><p>In the photo, the original is on the left and the remix is on the right. The remix is about 8 mm taller.</p><p>&nbsp;</p>