Microsoft Surface Pro 3 Wall Mount

thingiverse

Update: 09/05/2016: I added another Anchor point on the bottom of the bracket to give it a nice complete seal on the wall. Depending on how its screwed in and if the wall is flush, the bottom with start pulling up as seen in one of the original pictures. This is a Microsoft Surface Pro 3 Wall mount. I designed this cause all the other designs I saw on Thingiverse did not allow me to keep my surface inside its case. The case is a UAG Surface pro 3 Case with a Microsoft keyboard cover attached. Nothing needs to be removed when placed in the dock as you can see from the pictures. The only thing is if you have this exact same case you will need to extend the charging port opening if you wish to use the dock station Microsoft provides as an accessory. The Case does not give enough clearance to the dock but since its rubber, i just used an exact-o knife and cut away to get the right size. If not then just use the regular charger and turn it upside down. It will still charge. Post-Printing Special Note Use drywall anchors as to prevent the weight from making the surface fall. How I Designed This Measurments This was measured witha caliper from the highest point on the corners of the case.