Mike242 MG3 Add-On

thingiverse

This part is an add-on to Mike242's MG3 Design(https://www.thingiverse.com/thing:2286818). PLEASE NOTE : This will only fit if the rear end of the receiver and stock are modified to a more realistic state. As seen in my make (https://www.thingiverse.com/make:745869). this part could be further modified to be used directly on Mike242's receiver design, But ill leave that up to you. I havent installed this part or printed it yet, so modifications may be required. Photos of the part and the look when installed will be posted when completed..updates to design will also be posted..UPDATE**...the part is printed and installed as seen...seems to be a decent fit and sizing...might want to make the width a few mm wider depending on your build..