miller spectrum 625 Automation plugs

thingiverse

So, I wanted to use my miller spectrum 625 plasma cutter with Langmuir systems CNC Plasma Table. I didn't want to splice the wires inside the unit and risk voiding the warranty of new Plasma cutter. These go between the Torch harness and the control board inside plasma cutter. I basically made a 3 way split (Like 4 wires coming out of male end(one per slot) then I placed two wires inside female connector 6 wires total (4 going to the wiring harness and 2 going out for torch controller) if that even makes any sense to anyone beside me. I printed this in PLA to start with, but will end up with nylon once i finished with the entire project. I didn't add clasp on this because its not really not needed and i couldn't get it to print right.