Miller welder bottom slide mount

thingiverse

needed to mount the miller 161stl TIG welder on a small cart vertically. only weighs 13lbs so i made these and used two in the slots under the base. 40% infill held ok but was a bit soft around the 5/16 bolts while tightening so using an adaptive infill to beef up that area while printing would be my only recommendation. for me and the tolerances of my machine these were a very snug fit. I added the obj file if you would like to tinker with it to achieve the best fit for you. I printed standing on end and that made for a good even tolerance the entire length and small chamfers on all edges including the bottom to eliminate any possibilities of elephants foot issues and to give a nice look and fit.