Milwaukee Fuel TS100 Power Adaptor

prusaprinters

<p>An adaptor based on macsboost's Milwaukee connector, to allow you to use your TS100 soldering iron on an M18 Fuel battery.</p> <h3>Print instructions</h3><h3>Category: Electronics Summary</h3> <p>An adaptor based on macsboost's Milwaukee connector, to allow you to use your TS100 soldering iron on an M18 Fuel battery.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK3</p>&lt;/div&gt;<strong>Supports:</strong></div></p> <p>No</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2</p>&lt;/div&gt;<strong>Infill:</strong></div></p> <p>20%</p> <h3> <strong>Filament:</strong> Sunlu PETG Black <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>Print the main adaptor body with the largest face down. Print the small wiring cover with the side the that the wire exits down.</p></div> Post-Printing</h3> <p>Clean holes up my running appropriate sized drills through them. I printed without supports, so needed to do a bit of clean up on the overhanging rails that the battery slides onto / engages with.</p> <p>Spade terminals are epoxied into the channels in the main body so they don't get pushed back into the adaptor when you slide it onto the battery.</p> <p>Wiring cover is secured with two M3 x 6 self tapping cap head screws.</p> <p>The cable is wired so that the plug that is inserted into the iron is centre positive. Plug is 5.5 x 2.5mm.</p></p></p>