Minecraft Torch Holder

thingiverse

An all in one wall mount for a Minecraft Torch, which allows the torch to be easily slid in, then pulled out again in order to replace batteries. Or go on adventures! This incorporated screwholes into the base which removes the need for an additional lip to secure to the wall. The holder will fit a torch 6cm x 6cm (The one we have is actually around 5.8cm, so the torch slides in and out without any difficulty), and is angled at 45 degrees. The screw holes are designed to fit a screw with a head no larger than 1cm and shaft no wider than 4mm. There is no need to print support as the 45 degree angle should be fine. mine printed with no issues, I did however use a raft to ensure good build plate adhesion. The walls are only 3mm thick, so not much infil is required.