Mini Drak Air Ducts

thingiverse

This is a remix of a file from Sigs I resized and shaped these to fit the RiteWing Mini Draks bay cover holes to provide better airflow into and out of the electronics compartments. There are 3 parts for the main bay cover. I did not create one for the very front tear drop shaped opening, these are only for the 3 square openings on the cover. I felt putting anything on the very front was over kill plus anything up there would hit when cover is fully open. The 3 files consist of 3 different sizes. The 6mm tall duct is for the front opening. There are 2 8mm tall ducts, one is wider than the other. The wider one goes on the rear opening and faces to the rear to allow air to escape. The narrower 8mm tall one goes in the middle. Also pictured are the smaller ducts for the side bays, I will upload them shortly.