Mini FPV V-Quadcopter by jsobanski (Inspired by Emaglio)

thingiverse

THIS IS STILL A WORK IN PROGRESS Hi everyone. Emaglio (Creator of the Mini FPV Tricopter) is a good friend of mine and suggested I create a V-Quadcopter for the community. I've been busy with work and school but I'd like to test the waters with the design here on thingiverse! Like I mentioned before this is still a work in progress, and has yet to actually fly.I am hoping to get some good feedback to tweak the design so everyone is happy, and maybe see a few get airborn ;). I should note, the STL's that I have uploaded are with the changes I needed to make to accommodate my printer. This included widening the rear arm slots by .3mm. If lots of people run into problems I can upload a new STL. Hopefully they yield successful results for you! General parts list SunnySky 2204 2300kV motors Gemfan 5x3 Props Magic 12A ESCs with SimonK 3S 1200mah -1300mah Battery (depending on size) Naze32 Flight Controller PZ0420M FPV Camera 3mm hardware Please leave comments and suggestions! Instructions Everything should be a snap fit and stay nice and snug with an assortment of 3mm hex bolts. You'll need 10mm, 15mm, and 35mm with a nut. Bottom Solid Layers: 3 Top Solid Layers: 3 Layer height: 0.2mm Number of Perimeters: 2