Mini Hovercraft

thingiverse

I got some mini quadrocopter stuff over, so I made this hovercraft in a size for my Ender 3 printer. The parts I used was Kiss 24A ESC's and BrotherHobby Returner R4 2206 2300KV motors, connected to an PDB mainly to get 5v for an Eachine AIO Camera/VTX and Frsky FrSky X4RSB receiver. But this was just what I had atm. Note: The plastic pegs on the rudders that holds the rudder bars are a little bit weak, I've replaced most of them with screws or a little bit of wire that I heated and melted it into the rudder. I might redesign this. https://youtu.be/sxu90_0dEj0 Edit 190107; Added "ring Large.stl" and "bottom Large.stl" for better stability. The ring is in TPU and bottom in PLA. Edit 190202: Added rudder_v2.stl and rudder middle_v2.stl with 2mm holes for screws for holding the top bars instead of the plastic pegs.