Mini Skywalker Motor Mount

thingiverse

Printed motor mount for the mini skywalker plane from hobbyking. Attaches to the main fuselage and allows the wing to fit inside the models original box for storage. 12mm ,16mm and 16.5mm (for AXN motor) spacing options. Bolts can either be from the back or from the front with nuts in the press-fit hex cavities. Fits 2-56 nuts maybe M-2 New and improved to better accommodate 6" props and I added a 16.5mm version for the AXN motor Instructions Goes between the two fuselage halves. Some foam will have to be removed but it should still be fairly simple to slice out and add this to an already completed model. 30%- 40% infill should be adequate. Might need some support for the arched overhang part **Note - before gluing, make sure the the motor angle lines up w/ the mount area on the wing. On mine, I had to tilt the motor 'up' slightly to achieve the correct position- the the top edge of the fuselage part of the motor mount is flush aft but drops about 1mm below the foam at the fore corner. Yours may be a little different.