Mini Talon Canopy for Runcam Split ( Pan/Tilt )

thingiverse

the mount is a remix from iSheeZ here on thingiverse i liked the design but where the runcam split was mounted was not so great for the air flow so a re-engineered the hole mount from scratch you will need 2x m3 18mm split board 2x m3 8mm split board 2x m3 nuts lid 2x m3 10mm tilt mount 2x 12g servo ( Im using one es09md that is modded with 2 3k ohm resistor to get a 180degree turn ) and 1 generic servo for the tilt mount . . . . . . .. . . .. To all that will test this setup.. i my self i having some interference from the split board to the GPS there is some information on forum at RC groups on this.. i will test to shield of the borad with copper tejp on the inside of the mounting hole for the split bored will try to test it out ASAP and give you the result