Mini Tesla Turbine

thingiverse

This is a small model of working Tesla turbine. It is good to use it with compressed air. To assemble it you need one 624zz bearing (4mm x 13mm x 5mm) and 3x M3x8. To avoid supports between shaft plates it is recommended to print shaft horizontally on raft and use support for thin shaft end only. You can print long_shaft.stl if you want to power something with this turbine :) Here you can find boat powered by this turbine: http://www.thingiverse.com/thing:1101425 Print Settings Rafts: Yes Supports: Yes Resolution: max 0.2mm per layer Infill: 15 to 50 % Notes: Print shaft horizontally on raft to avoid supports between plates. Use supports for long/short end of shaft.