Mini Toolbox - chocolate holder

thingiverse

ABOUT This is a toolbox that can hold chocolate balls or lollies. Makes a nice presentation box. INSTRUCTIONS To make, you need to print: 1x Base 2x Drawer 4x Choc Insert 4x Long Rod 8x Short Rod 2x Lid 2x Handle 28x Snap-plugs Put 2 choc holders in base. Load a choc holder into each drawer. Attach rods to ends drawers and hold in place with snap-plugs. Attach rods drawers to base with snap-plugs in the rods. Attach lid using snap-plugs. Pop in handles into lids. CHANGELOG 18/12/2015: Added Washer part - because I ran out of M3 washers. I'm thinking it may be possible to make a snap-in part rather than use screws and nuts. Some testing required. 19/12/2015: Updated Choc Insert so it can be printed more easily - bottom of hemispheres held together before they're joined. 20/12/2015: Added Snap-plugs. This removes need for any hardware (was using M3 nuts, washers and bolts). Model is now completely 3D printable. 21/12/2015: Test print is complete. The snap-in plugs seem to work OK. Two things: The lid opens a bit when it is being carried by the handles, and the rods are probably a bit thin. So I'll need to work on that - but otherwise it's OK. I might also get to making some other inserts to use but for the moment it holds Lindt chocolate balls.