Mini UBLOX M8N 35x35 case

thingiverse

Compact enclosure to provide minimal protection for the 35x35 Mini UBLOX M8N GPS. I got mine from RTF Quads:http://www.readytoflyquads.com/mini-ublox-m8n-gps-w-35x35mm-mounting-backplane-and-compass Features: Strain relief (by way of a curved surface) at cable entry Locating pins protrude all the way through the top of the case so you can use a low temperature soldering iron or hot glue to secure the case together. 'Lands' for the PCB to sit on in the case. The small hole in the bottom half of the case is to permit you to see the status LEDs. My GPS will be mounted with velcro/doublesided tape to the underside of the wing. Status LEDs will be visible below. Print Settings Printer Brand: RepRap Printer: Prusa i3 Rafts: No Supports: No Resolution: 100 micron Infill: 100% Notes: I printed this at 0.1mm layer height with 100% infill. It should work at lower resolutions, but you may lose resolution on the very small 'strain relief' for the cable entry. I suggest printing with a brim of at least 2mm.