Minimalistic Ender 3 Enclosure for Bigtreetech SKR 1.4

prusaprinters

<p>A minimalistic electronics enclosure to put the BigtreeTech SKR 1.4 in a box at the front of an Creality Ender 3.</p> <h3>Print instructions</h3><p><strong>Design goals:</strong></p> <ul> <li>Under 2 hr print.</li> <li>No supports.</li> <li>Viewable faces flat on the bed for best finish.</li> <li>Reuse of screws (M3's did not work out they are too short).</li> <li>No extra screws -&gt; the back snaps in the 4040 profile.</li> <li>Reuse of standard lid (and fan) so I didn't have to print that.</li> </ul> <p><strong>Print Instructions:</strong></p> <ul> <li>No support</li> <li>100% infill</li> <li>0.16mm layer height</li> </ul> <p><strong>Rationale</strong><br/> All of the enclosures I could find used to much plastic, supports, different mounting hardware etc.</p> <p>After upgrading to a BTT SKR 1.4 on my Creality Ender 3, I needed somewhere to put my board. Preferably in the front. Teaching Tech has one for the back.</p> <p>It is made for the Ender 3 and the BTT SKR 1.4. But if sufficient interest, I could adapt this to other boards/printers.</p>