Minion lamp

cults3d

To make this a very useful thing, in addition to printed stl files, you need the following elements: • Downlight Led Ceiling 5w (It is important that the largest diameter of the downlight led ceiling is 68 mm and it is put into a hole with a diameter of 55 mm). https://www.aliexpress.com/item/4000929860358.html • Push Button Switch https://www.aliexpress.com/item/1000005699023.html • Cable • 2 Pin Electric Plug • Screw M4x25, 2 pieces and nut M4, 2 pieces for fastening the lamp to the stand • Screw M3x15, 1 piece and nut M3, 1 piece for holding the graduate cap on the head if you made it • Screw M3x10, 2 pieces and nut M3, 2 pieces for holding the cover on the stand. You can make a lamp with a graduate cap and then print the Minion upper half with a hole, the graduate cap and the nut cap. If you make a lamp without a graduate cap, then you print only the Minion upper half. You can mount the downlight led ceiling with springs or you can print the downlight holder and use them instead for easier mounting. After assembling all the printed parts, mount the downlight led ceiling, pass the wires through the holes in the legs, connect the push button switch from the bottom side and put the cover on the stand. At the bottom of the stand, there are four square recesses for silicone feet for better gripping of the table lamp, although in my case it turned out to be unnecessary.