Mirror Arm GoPro Clamp Yamaha FZ1-S

thingiverse

Clamp your GoPro to your rear mirror arm on your Yamaha FZ1-S. The arm is not round shaped and its also hard to clamp anything without damaging the arm. The small part will "make" the arm round shaped so a clamp can be used. The small part is supposed to be printed in flexible material. This is for two reasons. To be able to fit it it needs to be "opened" by bending it out like a "jaw". Not to damage or scratch the mirror arm. This part should be attach in the correct direction. The irregular hole doesn't have the same dimensions through the entire part. The clamp should be printed in a hard material. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: 0,2 Infill: 30% Custom Section Harware needed: A quick release clamp is needed. Search for "Quick Release Bicycle clamp" on eBay, Amazon, Ali...and you will find one. Cost approx $1 or so. The camera adapter can be found on eBay, search for "tripod adapter 1/4 inch gopro". Bicycle clamp 1/4 inch to GoPro adapter