mirror radar mount for BMW f30

thingiverse

This is my first contribution to thingiverse! This was built around a BMW f30 (2012-2018 3 series) rear view mirror with drivers assistant option (has KAFAS camera, check on your top center of your windsheild for the word "Connected Drive") should fit other mirrors and Escort x70 radar detector. I printed with PLA, 80% infill and then annealed it at 175F for 40 minutes and let it cool down on its own in the toaster oven. Make sure that the elements don't turn on at full power after the initial warm up as mine doesn't. Without annealing PLA, it WILL melt the printed part in 10 minutes in the hot summer heat. The top part of the clamp has an partially embedded nut, and I believe the size was #8, its a tight fit but it will fit. I used 1-1/4" machine screw for the clamps. PS- the photo on here has some random screws. They were during the fitment testing phase. Replaced all with machine screws. Feed backs are welcomed!