MKS Base And MKS-TFT28 Housing

thingiverse

This is a housing I designed to fit my MKS Base and MKS-TFT28 along with a mosfet for the heatbed to sit next to my Delta for easy control and wiring. For the back plate I designed 2 versions. One where the cables just run trough the back plate and one for aviation type connectors. The Mosfet will be placed on the side. I used 60mm fans so I made proper holes to fit them on the top and back plate. To space out the MKS-TFT28 just right I needed to put 2.5mm spacers on one side and 3mm spacers on the other. Check yours to see what works best. Only parts where I used bolts AND nuts is to secure the MKS-TFT28, the fans and the mosfet. The other pieces are tapped with M4 so it would make assembly a lot easier. I printed everything with 10% infill and it turned out good so it should be sufficient. Up to you if you want to increase that value to make it stronger. If you put all the pieces right on the build plate you'll need a minimum on supports to print it, depends on how you place the parts.