MobBob2 adjustable Phone holder

thingiverse

Wanting to make a MobBob, I found that my phone didn't fit in the original MobBob Phone holder. So I redesigned it to be able to hold a range of phones wide or narrow and with or without their protective cover. I kept the dimensions of the attachement to the rest of the robot. All the parts can be easily printed without support. No need for screws or glue to assemble. First put the gear in place on the cover, clip the back to the cover and then slide the left and right braces in place while turning the gear. All thanks to Cevinius for creating such a cool little robot and app. Print Settings Supports: Doesn't Matter Resolution: 0.3 Infill: 20% Notes: I printed in relatively low resolution for speed and it works fine. Post-Printing The little latches on the cover plate serve to maintain the gear in position (so that the side braces don't move once you've set it to hold your phone) and should click when adjusting. There is a very small gap between the latch and the rest of the plate to allow it to flex. Depending on your pritner and settings, you might need to re-separate it with a small blade to ensure it is only attached at the pin. Otherwise I have included a small chamfer anyway but the latches will be stiffer.