Moblite 6 / 7 Canopy Camera Mount

thingiverse

I designed this to work with my moblite 6 to reduce the shaky stock mount. This weighs less than 1 gram and doubles as a nice roll cage for the quad. I believe the moblite 6, 7, and mobula 65/75 all have the same bolt-up so this may work for all 4. IMPORTANT: This is press fit on the camera, so its tight. Take a knife and scratch all 4 internal corners of this mount until the camera presses in without too much force, but be careful and not go too far as it wont be snug. IMPORTANT: Print 2-3 at a time so you dont put too much heat into 1 I used 1.2x6mm screws just to be safe $7 for a massive set on amazon. The stock screws did work but barely. I print using a 0.4mm ruby and recommend the following settings if using abs: 0.2mm layer height support at 10% 100% infill 45-55mm/s print speed.