Mod for DJI Air Unit with Rooster frame for FPV

thingiverse

Mod for DJI Air Unit --------------------- #####There are six pieces in total, on four of them I used TPU. While for the other two I used PLA. The file names have the filament I used. I recommend blocking supports in the bolts and nuts holes. ####DJI Air Unit extension + Also necessary to use 4x M3 bolts + and 2x 6mm M3 Female spacer + Glue the TPU and the PLA parts ####DJI Camera mount + Up to 45 degrees of angle tilt + Use 4x M2 screws #####Concept #####The design is guided by the extreme heat produced by both the Air Unit and the camera. I tried to touch as little as possible those pieces while maintaining good stability overall. My assumption is that it would assure a good heat dissipation. #####DISCLAIMER #####There is no warranty for these parts. The quality and performance of the parts are up to you. Should the parts prove defective, you assume the cost of all necessary servicing, repair, or correction.