Modified accessory mount for Solidoodle jigsaw replacement extruder MK5

thingiverse

I found with Lawsys MK5 jigsaw replacement extruder setup that my extruder would pull forward and back when the filament was retracted. This modified clip holds the peek barrel in a bit better and prevents this movement. The only difference in the two versions are the v2 one has a cut-out to reduce contact with the peek and allow a bit of air around it as I'm not sure how hot it will get if it's running for hours. Either should work the same. Instructions This is a modified version of the fan mount but it can also be used as the 'blank' clip just to support the extruder. It's a tight fit and I broke my mount posts off the first time I clipped on, but as you can see from the pics I have screwed them on and now it works well. Note: This might not fit all Solidoodle heater/extruder setups.