Modified SN04 Z Adjuster for Tevo Tarantula

thingiverse

The original slider was a bit too narrow to properly house two M3 nuts to fasten the SN04 sensor to the slider. Therefore I made the slider a bit wider. Moreover, I reduced the gap between slider and holder to 0.2 in all directions so the slider can't wiggle as much. This worked for me without any post print processing. For a less precise printer it may be neccessary to increase the gap a bit. For that reason, the Sketchup file is included. You will need: * 1x M3x30 bolt (preferably hex socket) * 2x M3x20 bolt * 3x M3 nut * A spring (the spring from a ball pen works fine) Two of the M3 nuts and the M3x20 bolts are usually used for the original sensor mount and included in the Tarantula kit.