MODULAR RACK FOR PAINT CANS 17ML

cults3d

Free of charge. Forever. Modular rack or shelf for paint cans with 17ml* dripper usual in different brands of paint for modelism (Diameter 25mm). Completely modular system, stackable and increasable. No need for supports! *IMPORTANT NOTE: Not suitable for other types of boats! Only suitable for boats similar to those shown. The system consists of: -2x Lateral support parts (left and right) -6x Support base parts (from 2 to 7 small holes) -6x Base units with holes (from 2 to 7 large holes) -1x Stand for vertical boat support up to 4 floors (must be printed in pairs) -1x Stand for tilted boat support up to 4 floors (must be printed in pairs) The system allows the creation of a shelf system adapted to the user's space needs. The boat can be placed upside down or upside down. Thanks to the included feet, a standard shelving system of up to 4 shelves can be created with the boats arranged vertically, or an inclined shelving system of up to 4 shelves. The individual module can be placed on a custom-made table and have as many modules as desired. It can even be installed vertically to have a horizontal boat arrangement. The modules can be printed in different colours, either to sort the paintings by colour or for simple creative taste! The system requires assembly and installation. The assembly is very simple, does not require tools and can be seen in the video at the following link: https://www.youtube.com/watch?v=8yXzq2xjKgk No glue is required, but it can be used for greater rigidity. If printing on PLA, use cyanoacrylate glue. The parts shown in the pictures have been assembled without glue. NOTE: Depending on the printing parameters of the parts, the assembly may offer a slight sagging of the longer "hollow base" parts. This should not pose a problem for proper operation. The installation of already assembled modules requires additional materials that the user must purchase separately (see below) Stackable installation requires the use of bases with the same size. The sides must be superimposed on each other. The following video shows an installation of two example shelves: https://www.youtube.com/watch?v=LF9KXsuqdws If the supplied feet are used, nuts must be inserted into the provided housings (the video shows 3 methods for this) Installation requires the following additional materials: CASE OF INSTALLATION WITH 2 FEET INCLUDED (SAME TYPE) -Nuts (4x DIN 934 M4 per foot) -Screws (2x countersunk screw** M4 x 20 per height) **The screws of the upper height can be cylindrical head, in that case it is convenient to use M4 x 16. CASE OF INSTALLATION ON OWN MEDIA In case of using own support, the options can be variable and adaptable by the user. Here are my recommendations: -Rugged*** support, chipboard type or similar, minimum thickness between 16 and 20mm, fixed to the wall, for board sizes equal to or less than 1m x 1m. -Screws (2x countersunk screw D3.5 or D4 x 20 for each height) -Screws and plugs for wall mounting*** ***By downloading these files, the user accepts his own responsibility for using an appropriate support for the number of boats he will need, in size and weight, and a suitable way of fixing them to the wall. I am not responsible for any damage that may be caused by not using an appropriate support or the included feet.