MOLLE clip for FoamBlast Mag Carrier: Single Loop

thingiverse

So I didn't do my homework and bough a MOLLE belt that only had a single loop, not realizing that the clips Meishel suggests require a minimum of two loops. This piece interfaces with the FoamBlast mag carrier to make it compatible with single loop MOLLE. Props to her mag carrier, linked below. https://www.thingiverse.com/thing:2544018 This piece is nice because it snaps directly onto the mag carrier and doesn't come off unless you specifically try to take it off. After printing one and playing around with it, it should be fairly obvious how to attach it. The bigger hinge snaps onto the extrusion on the mag carrier with a triangular cut out. Attach how its pictured (by feeding the smaller hinge through both extrusions) rather than running it along the outside, so that carrier is snug on your MOLLE gear. Don't forget to click in the really tiny hinge after clicking in the main hinge. If this is confusing I can upload a video but I think people can figure it out.