Monopoly Jail Cell

myminifactory

Monopoly Jail Cell This is a Jail Cell for the Monopoly board games. It is designed to fit in the jail cell space on the original board game, but it should also fit other editions with a standard jail space. It is printed in two parts; base/bars and cap.  Disclaimer Although I usually print at a layer height of .1mm, the cell in the picture was printed at .2mm because most people seem to print at that layer height. I also used the cheap fillament that came with my printer to print this, as I didn't want to waste my hatchbox fillament. So the bars have a bunch of fairly large start/stop marks, on which I only spent about a minute trying to clean up. Also, the cap was only pressed into place and not epoxied, as I'd normally do. So with quality fillament, finer printer settings, and a few minutes spent cleaning up, this jail cell will look much better. General Printer Settings Layer Height                       .2mm                    Top/Bottom/Perimeter          3 layers Infill                                   20% Print Time                                  1h 03 m Fillament Length                 3124.9 mm Platic Weight                      9.40 g