Monoprice Maker Ultimate Filament Guide v1

thingiverse

This is my first shot at using Autodesk 123D Design to make a printable object! What you see here is my attempt at making a filament guide for the Monoprice Maker Ultimate 3D Printer. My biggest issue was the filament jumping off the spool and tangling between the printer and spool. I do plan on making it better. But for now, it is doing it's job! The best part about this mod is that it's a quick fix until you can find something better. It prints in a short amount of time and does the intended job. Print Settings Printer: Maker Ultimate 3D Rafts: Yes Supports: No Resolution: .2 Infill: 10% Notes: Filament: MeltInk3d 1.75mm PLA (Cool Gray) Filament used: 1.609m 4.0g Extruder Temp: 195° Bed Temp: 50° Walls: 0.8 Speed: 50mm/s