Monoprice Mini Bed Upgrade

prusaprinters

<p>These parts make up a total bed exchange for a Monoprice Mini. This add manual leveling to mine, which did not have it.</p> <p>Check out the assembly video: <a href="https://youtu.be/7QtzCL9a45Q">https://youtu.be/7QtzCL9a45Q</a></p> <p><strong>UPDATED 1/3/2021</strong></p> <p>Heated Bed Upgrade: <a href="https://www.thingiverse.com/thing:4726170">https://www.thingiverse.com/thing:4726170</a></p> <p>All parts fit on the printer. I printed them using PLA. Used a 15% cubic infill for all parts.</p> <p>The rod clamps and bed trays need a brim.</p> <p>Bed ends should be printed on their back, with supports.</p> <p>This can also be used to extend the bed in the y-direction by replacing the linear rods and increasing the length of the tray spacers.</p> <p>Relationships for increasing the bed length:</p> <p>Bed = Rod - 30</p> <p>Spacer = Rod - 62</p> <p>Spacer = Bed - 98</p> <p>Rod = Bed + 30</p> <p>Parts:</p> <p>(2) Bed Ends</p> <p>(4) Rod Clamps</p> <p>(2) Belt Clamps</p> <p>(2) Bed Trays</p> <p>(2) Tray Spacers</p> <p>Hardware:</p> <p>(20) 20mm M3 screws</p> <p>(20) M3 nuts</p> <p>(8) M3 washers</p> <p>(2) Pens springs, cut in half</p> <p>Belt (about 30cm)</p> <p>Tensinoer (reuse from printer)</p> <p>Linear Rods (reuse from printer)</p> <p>Glass bed</p> <p>Z-Axis spacer</p> <p>Bellow are the purchased parts that I used for this, as well as the Z-Spacer I used.</p> <p>Belt: <a href="https://www.ebay.com/itm/Timing-Belt-GT2-16T-5mm-Bore-Pulley-5-Meters-For-3D-Printer-RepRap-Prusa-Mendel/254349190668?ssPageName=STRK%3AMEBIDX%3AIT&amp;_trksid=p2060353.m2749.l2649">https://www.ebay.com/itm/Timing-Belt-GT2-16T-5mm-Bore-Pulley-5-Meters-For-3D-Printer-RepRap-Prusa-Mendel/254349190668?ssPageName=STRK%3AMEBIDX%3AIT&amp;_trksid=p2060353.m2749.l2649</a></p> <p>Hardware Kit: https://www.amazon.com/gp/product/B07FCN64HV/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&amp;psc=1</p> <p>Glass Bed: https://www.amazon.com/gp/product/B071RS7DB2/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&amp;psc=1</p> <p>Z-Spacer (really any will work, this is just the one I use): <a href="https://www.thingiverse.com/thing:4563372">https://www.thingiverse.com/thing:4563372</a></p> Category: 3D Printer Parts