Monoprice Select Mini Spinner Knob MP

thingiverse

This is a replacement knob for the monoprice select mini which solves three basic problems. coned top allows rapid controlled wheel spinning without slipping off the dial taller to also allow side grip of the knob knurled sides to make side grip of the knob comfortable Printed at either .1mm or .06mm layer depth on the mp mini itself, it fits the shaft quite nicely. Print Settings Printer: Monoprice Select Mini Rafts: No Supports: No Resolution: 0.06mm or 0.1mm Infill: 20% triangle Notes: Most of the model is really easy to print cleanly. The top knobs are a little tougher but also easy to clean up once it's done. Post-Printing Cleanup and knob The top cones may have a bit of hanging string to them once complete since they're so small. removal should be easy though. I used the side of a swiss army knife awl to just scrape them off cleanly. Removing the original knob from the machine is supposedly easy to do by looping dental floss underneath and pulling it off. I actually removed mine by using the sharp edge of a knife alternating on either side to slowly pull it up. The new knob can be just pushed on and has enough sticking out to pull back off again easily in the future. The monoprice mini bare knob shaft