Monoprice Select Mini Tool Bracket

thingiverse

Remixed Tool Bracket for Monoprice Select Mini. Redesigned eburgess4's tool bracket to have tighter tolerances, Combined it with clayreimann's Tool Bracket to have only one open end to prevent tool holders from sliding all the way through, and then rounded some corners to make it less sharp and to follow the frame of the Monoprice Mini better. I am still fine tuning the filets on the corners to match the mini, so if you print it and have input please let me know. I will also likely add other tool holders as I think of things I need, If you would like to see something added let me know. If you print this out and like it, I would appreciate an "I made one". Print Settings Printer: Monoprice Select Mini Rafts: No Supports: Yes Resolution: .13125 Infill: 50 Notes: Print the mount on its end with the closed end down. This will minimize the supports needed and keep the channel for the tool holders clear. The SD card and Hex holder Should be printed as it would be installed. this insures the channel for the micro SD does not warp. Support may or may not be needed to support the angled part of the holder. Best results are without supports if you can get away with it, as the key way in the bracket is a close fit and flash from the supports may make it a bit tight at first. UPDATE: I have added a V2 version of this part that should allow for a little more clearance in the key way of the bracket itself. I have not tested this adjustment, but I reduced the size of the keyed portion of the holder by .5mm to allow a bit more room to slide in the bracket. If you print it out and it works, please let me know. The Tape Holder I have not printed, but should be printed on its side for strength reasons. It should not require any supports. Given the amount of leverage that this will place on the keyed portion of itself, it might be a good idea to use 100% infill to prevent it snapping off.