Mosfet & mainboard support frame for Anet A8

thingiverse

UPDATE:I uploaded a small, mini and micro version, basically, the only thing that matters is the bridge between the mainboard mount and the mosfet. If you use 4 the white washers that are originally used to mount the mainboard, on the upper side of the mainboard and the lower side of the mosfet, you're good to go. Faster print, less wasted plastic. Needed a frame for my mosfet board on my Anet A8. I thought The original design (1857006) was a bit wasteful, both in print time and plastic, since the design aspect would be completely covered by the actual boards anyway. Hence this design, which saves +/- 50% of time and plastic. I actually designed this from the ground up with Adobe Illustrator and Blender, but i did use Sjouke's file for measurements. How to connect the mosfet board: https://3dprint.wiki/reprap/electronics/heatbed_mosfet Print Settings Printer Brand: RepRap Printer: Anet A8 Rafts: Doesn't Matter Supports: No Notes: I used 100% infill, 0.2mm layer height, printed with a brim. According to Cura, this should be about 13-14 grams (with 100% infill), less than 5 meters filament, and take about 1h10m.