mosquito

thingiverse

i have split this thing down the middle so it can be printed even at this size it is extremely delicate i used low quality abs made with my fillastruder so there was a lot of stringing and i printed it at standard xyzware .3mm on my xyz duo printer i think if you print with better quality filament and lower layer height yours should come out better i have never had to change layer height but i think this critter needs it i might print this again with better filament and lower layer height but i want to move along to the next critter and this does not look so bad after cleaning all the strings this i recommend xyz filament it is extremely expensive but it has the best quality i keep a few roles around just for these occasions