Mother of All Wreaths Mount PVC and EMT

thingiverse

This series of mounts is designed to fit the Gilbert Engineering Mother of All Wreaths. Versions for both PVC and EMT are included. 1/2" PVC or EMT slides between the openings in each mount to create a support structure behind the coro. At the back of each mount a screw is used to secure the PVC or EMT and a cross PVC connector is used at the center to connect the perpendicular PVC or EMT sides. If using EMT conduit there is an EMT bushing stl to allow a secure fit of the smaller EMT conduit into a PVC cross. It also allows for one section of EMT to run continuously through the cross as one piece for added rigidity. Ideally attach mounts prior to inserting pixels otherwise affected pixels will have to be removed to install mounts. There is also an alternate mount for the MOAW that does not have PVC or EMT in the center of the wreath. https://www.thingiverse.com/thing:3845904 Note: While the MOAW looks symmetrical, there are small variations of several millimeters between hole locations. As a result the fit of these parts will vary slightly depending on placement. Pixel holes are oversized to account for this variability. In the graphic, the PVC is depicted in orange for illustration purposes.