Motorola Moto X4 Phone Charging Stand Holder

thingiverse

# Versatile Phone Stand This phone stand was designed to fit a Motorola Moto X4 with a slim case, but will accommodate a number of similarly sized phones. It fits my LG v30 quite well. The phone width is 7.9 cm, thickness 1.2 cm. This will fit a wide number of USB cables. It was designed for the chunkier braided nylon wrapped USB cables, so smaller cables might fit in there a bit loosely. The cover on the front should help to hold the cables in, and you can always use a bit of hot glue to keep them in there nice and tight. This prints well without supports, using the orientation shown in the slicer images. The front cover fits on very tightly as designed, so no need to print the case at a higher percentage to get the cover to fit. There are screwdriver notches in the cover to allow removal. ### How it was designed I used Cinema4D to make this model. Not a popular choice, but it's what I have and know how to use.