Motorola Moto X4 phone stand

thingiverse

This is a stand for the Motorola Moto X4 phone. It is a two piece design that should be glued together. The column is hollow and should be filled with sand to give the stand some heft and keep it in place. The power/data cable fits but you will need to be close to an edge as the cord isn’t flexible enough to bend out of the way. A headphone jack WON’T fit – I don’t use one. ###Printer settings: - Support: None - You don’t need much infill at all – I use 5%. - Layer height: 0.20mm (use prusaSlicers 0.02mm QUALITY setting) ###To assemble: Print. You’ll probably need to remove flash from the socket in the cradle. Use a scraper (6" steel rule or box knife) to deburr the edges. Use a dragging motion (negative rake). Press fit. It is a tight fit so take a bit of care. It will seem solid but will move over time so glue is a good idea. Fill the column with sand (or whatever), then glue the cradle on. Super glue works well. Do several trial fits first! https://youtu.be/bGj-Rx5v3UA https://youtu.be/OmURlbcq0_A