MotorPixie 2-axis gimbal for DJI Phantom 2 Vision (FC200 edition) - Discontinued

thingiverse

Discontinued - see http://www.thingiverse.com/thing:454791 instead. 2 axis gimbal for DJI Phantom 2 Vision (non plus) for FC200 camera. This is how I do my testing: http://youtu.be/ApPEFi2EdyM 27/6/2014: Added dampener plate (body plate) for Phantom 2 Vision Added dampener plate (body plate) for FC40 / Phantom 1 24/6/2014: Added support for GoPro Hero 3(+) GoPro enclosure added GoPro enclosure clamp added New versions 22/6/2014: Updated FC200 enclosure to make adjusting balance point easier Updated pitch arm to make adjusting balance point easier and there is now clearance 360. Updated baseplate to accommodate 360 clearance and nicer cabling. Updated BaseCam case to make board fit within confines of box. Easier access to cables. Reduced height by 1mm. Note: IMU box is subject to change. Instructions To complete this build, you will also need: 1x Basecam 2 axis controller board with IMU 2x Turnigy 2206-140Kv gimbal motors 8x M3x8 hex screws 8x M2x6 hex screws 8x M2 (4.8x0.3mm) washers (ADDED 22/6/2014) 6x M3x20 nylon screws 1x M3x16 screw 1x M3 nut 1x 3.5mm female 4 pole jack 1x 3.5mm male 4 pole jack with wires (90 degree angle) 1x 50mm 1 pin wire (pitch control) 4x "red" (300g) dampeners Mad soldering skills FC200 specific: 1x M3x16 screw 1x M3 nut GoPro Hero 3(+) specific: 2x M3x16 screw 2x M3 nut Plastic tubing to protect exposed FC200 jack (Next rev: additional 4x M3x16 screws, 4x M3 nuts - dampeners)