Mount and Bracket for DJI Crystalsky and Phantom 4 - V2

thingiverse

I went back to the drawing board and designed a drop in replacement for the Phantom 4 support arm that is much improved from my previous design. The three biggest improvements are: You no longer need to modify your original P4 arm, the joining / rotating parts have teeth so lock in at various angles, and the remote / arm fit inside the original Phantom case without hitting the P4 camera. To install, remove the original P4 support arm and phone holder, leaving the metal post at the top of the controller. Press the printed arm into place and install a screw to secure it. It should be a fairly snug fit so you might need to press a bit hard (but not so hard that if feels like you are going to break your remote!). You will need: 3 - 5mm x 15mm screws 1 - 5mm x 40mm screw 2 - 5mm nuts