Mount for Adafruit NeoPixel LED Dots Strand

thingiverse

Two part part press fit design for mounting a [strand of Adafruit NeoPixel LED](https://www.adafruit.com/product/3630) to a sheet of 2.7mm cardboard. * Cut an approximately 18 mm round hole in the cardboard * Out one of the pixels through the hole * Push the back (the larger part with the fingers) up throughout the bottom, so the neck extends above the cardboard and sandwiching the LED strand between the cardboard and the the part. * Finally fit the front (the round sloped piece) over the front to hold everything in place. Designed in OnShape: https://cad.onshape.com/documents/2a124e052cd9918069d237ac/w/a4afcc2cd74a87c4e6679b02/m/c06523303067d4f60ad4cac4/e/f32894142e2258986cd043e8 Printed on a Prusa Mini in Prusament Jet Black. The front part has overhangs in either orientation. Generally found it prints better upside down (so the cone points down). The overhand is bigger, but at least on my Prusa the 45 degree angle prints fine. led-mount-template-4.stl is a template you can use to mark the correct size circle to cutout. the center hole is size for a push pin. https://twoprojects389502217.wordpress.com/2022/02/22/side-project-mount-for-neopixel-led-dots-strand/