Mount for Autolevel-Sensor (Work In Progress)

thingiverse

This mount enables the magnetic base to be securely attached to the BantaMount (model 3543121).\r\n\r\nDesigned with TINKERCAD.\r\n\r\nUPDATE:\r\n=========\r\n\r\nI successfully used this mount from the start, and it has proven stable enough to deliver consistent results, as tested through marlin probe accuracy testing.\r\n\r\nThe main issue is that it's not compatible with the standard firmware.\r\n(I haven't tested, but offsets are large and you can only set z-offset)\r\n\r\nAdditionally, on the right side, homing without causing bed crashes is problematic.\r\n\r\nIn marlin, adjusting probe offset is straightforward; here are my settings:\r\n define X_PROBE_OFFSET_FROM_EXTRUDER 20 // X offset: -left +right [of the nozzle]\r\n define Y_PROBE_OFFSET_FROM_EXTRUDER -13 // Y offset: -front +behind [the nozzle]\r\n define Z_PROBE_OFFSET_FROM_EXTRUDER -25 // Z offset: -below +above [the nozzle]\r\n\r\nConfiguring Mesh-Bed-leveling is up to your preference. I will post my configuration below.\r\n\r\nMy Mesh Creation:\r\nG28 #Home\r\nG0 z50# Lift the head slightly\r\nG0 x200 y200 #Move to the middle of the bed, attach probe\r\nG29 #Perform a Bed leveling with probe attached\r\nM420 S # Load your new mesh\r\nG28 #G0 z50 # G0 x200 y200 # Same as before for safety, remove probe\r\n\r\nFine tuning if your probe offset in firmware is not perfect:\r\nG0 Z0 # Move to zero, try higher values to prevent crash\r\nM206 Z-1 #To move up your Offset by 1mm\r\nG0 Z1\r\nG0 Z0 # Sometimes it will accept offset when you move up and down again\r\n\r\n=> Do the papertest and testprint until you are satisfied with your M206 Value.\r\nM500 To save everything to Memory \r\n\r\nI have since moved to a direct setup.\r\nBig thanks for this thing: https://www.thingiverse.com/thing:3586698